Jason 35 Pilothouse Offshore

US$43,900.00 (Approx £35,027) Reduced
  • Boat REF#  ·  323146
  • LOA  ·  10.67m
  • Year  ·  1977
  • Construction  ·  GRP
  • Underwater profile  ·  Fin
  • Berths  ·  3
  • Engine  ·  1 x Diesel 52hp, Perkins 4-108 (1977)
  • Lying  ·  Kenmore, WA USA - Shown by Appointment
Boatshed Seattle
Boatshed Seattle
Gary Buck

Extra Details

Designer Ted Brewer
Builder Miller Marine
Lying Kenmore, WA USA - Shown by Appointment
Fuel capacity 272.7 ltr (60.0 G) Total - 1 Tanks
Water capacity 113.6 ltr (25.0 G) Total - 1 Tanks
Holding tank capacity 90.9 ltr (20.0 G) Total - 1 Tanks

Mechanical

Engine 1 x Diesel 52hp
Engine make and model Perkins 4-108 (1977)
Engine Hours engine1= 1238
Engine Cooled Indirect
Steering Wheel
Drive Shaft
Prop(s) 3 blade PYI MAX Auto feathering
Fuel consumption (approx) 4.5 ltr (1.0 G) /hour At Cruising Speed
Cruising speed (approx) 5 knots
Max speed (approx) 7 knots

The engine received new mounts about nine years ago. Borg-Warner AS7-71C Gear Box, ratio 1.9 : 1, original prop as a spare, stainless steel exhaust system with fiberglass muffler, Perko intake water stainer, Racor fuel filter, 60 gallon Monel fuel tank with level gauge in pilothouse, numerous spare parts such as injectors, impeller, belts, etc.

Two 8D Battery boxes today house two Duracell SLIGC115 6V 230 AMP Deep Cycle Batteries approx. 1 year old. There are also two batteries in those boxes in need of replacement (not connected)

Dimensions

LOA 10.67m
LWL 8.33m
Beam 3.40m
Draft Max 1.52m
Airdraft 16.76m
Displacement 7,620kg (16,802.9lbs)
Headroom 1.93m
Storage On marina

Rig

Cutter rigged Aluminium spars (1977) with stainless steel standing rigging (1977)

Sails

Mainsail Buchan - Slab (1983) Fully Battened, Lazy Jacks, 2 Reefs
Headsail Buchan - Furling (1983)

The stays'l stay, self tacking boom, running backstays and the sail are removed and in storage all in very good condition. The tail end of the boom sits in a gallows. Head sail furling is Harken.

There's a 'Mast Mate' mast climbing system included: Home - Mastmate .

There is also a Spinnaker sail in excellent condition.

Electrical Systems

12 volt battery, 110 shore power voltage, 3 batteries charged by: engine, shore power

Construction

Construction GRP
Underwater profile Fin
Finish Gelcoat finish

Built in 1977 and launched in 1983. The seller reports the original owner spent 6 years on the interior custom joinery.

The keel design is a long fin with cutaway forefoot rounding to a skeg hung rudder. Canoe stern, boom gallow, cutter rigged (stays'l equipment removed and in storage).

The deep keel is integral to the design of the hull. Reports are that Miller Marine poured 6200 LBS of molten lead into the keels for ballast.

Waterline Boats / Boatshed does not independently verify capacities and measures, which are reported from seller-provided information and/or literature.

Accommodation

Total # of berths 3
No. of double berths 1
No. of single berths 2
Cabin(s) 2
Handbasin 1
Heads 1 heads (Manual)

Stepping down the companionway ladder into the pilothouse there is a quarterberth immediately to starboard extending aft under the cockpit. To port is a booth-style salon table. Ahead on the starboard is the helm with nav instruments. The windows in this compartment are covered with blinds. Forward and down two steps is the galley to port -- very nicely laid out with a two- burner propane range. The counters, fixtures and wood work are very attractive. To starboard from the galley is a sitting area that doubles as a single berth. Storage is everywhere. Ahead of the galley on port is the head with manual toilet. There is no shower however there is potential to create one fairly easy. There is a reverse osmosis system plumbed to shore water (not seawater...). So when moored with a fresh water connection, there's clean, filtered water available with a spigot at the galley sink. Water capacity is 25 gallons, with room to add more tanks (already plumbed with selector valves under the galley sink). The forward section of the bow is a "V" Berth cabin with single seat, big hatch overhead and again very nice woodwork.

2 burner gas cooker/stove

Accommodation

Cooker/stove
Grill
Oven
Sink
Refrigerator
Pressurised water system
Hot water system
Non-Smokers

Stepping down the companionway ladder into the pilothouse there is a quarterberth immediately to starboard extending aft under the cockpit. To port is a booth-style salon table. Ahead on the starboard is the helm with nav instruments. The windows in this compartment are covered with blinds. Forward and down two steps is the galley to port -- very nicely laid out with a two- burner propane range. The counters, fixtures and wood work are very attractive. To starboard from the galley is a sitting area that doubles as a single berth. Storage is everywhere. Ahead of the galley on port is the head with manual toilet. There is no shower however there is potential to create one fairly easy. There is a reverse osmosis system plumbed to shore water (not seawater...). So when moored with a fresh water connection, there's clean, filtered water available with a spigot at the galley sink. Water capacity is 25 gallons, with room to add more tanks (already plumbed with selector valves under the galley sink). The forward section of the bow is a "V" Berth cabin with single seat, big hatch overhead and again very nice woodwork.

2 burner gas cooker/stove

Deck Gear

Warps
Fenders
Boathook
Swim Ladder
Instrument Covers
Bow Thruster

3 halyard winches
2 sheet winches
Manual Ideal windlass
2 anchors
(CQR and Bruce)
10.67m of chain
76.20m of warp
Portland Pudgy dinghy (2014)
(Other)
Sheet winches are Barient 27s, Halyard winches are Barient 10. There are two anchors on a custom bow sprit 35 LB CQR and a 35 Bruce.

The Portland Pudgy dinghy has oars for power and a towing bridle.

Nav Equipment

Compass
Speed
Radar
VHF
Autopilot
Stereo
Clock
Barometer
Navigation lights
Fish Finder
Echo sounder

Raytheon Autohelm Radar, Garmin 160 Depth sounder / Fishfinder, iCOMM IC-M59 VHF, Standard Horizon SL-150 digital speed log, Panasonic AM/FM CD player in salon with speakers in "V" Berth, Pilothouse and cockpit.

Safety Equipment

Life jackets
Horn
Emergency steering

1 bilge pumps (1 manual / 0 Electric)

Bilge pump is located deep in the keel.

Broker's Comments

The Jason 35 is featured in the book “Best Boats to Build or Buy” by Ferenc Mate, and was designed by Ted Brewer for experienced owners who wanted a seaworthy, fast, maneuverable blue water cruiser. As a result, this vessel has many features that make it safer at sea, easier to handle (with bow thruster!) and more comfortable.

This boat was built as the "Pilothouse" version. The seller reports it was an owner-finished boat when built in 1977 but not finished and launched until 1983. Whoever that owner was who finished the interior certainly had some strong woodworker / carpenter skills! The interior is very attractively finished in several types of wood and with a headliner of strips of wood commonly referred to as "Captains Cabin".

Kept for the last 25 years in fresh water.

These boat details are subject to contract.
Note: Offers on the asking price may be considered.

Where the particulars herein give details of a boat, whether new or used, they are intended to give a fair description of the vessel but are not guaranteed as accurate or complete. They shall not form part of any offer or contract for the sale of the vessel. The prospective purchaser is recommended to independently check the particulars and the vessel. The vendor is not selling in the course of a business unless otherwise stated. Personal property is excluded from the sale of the vessel unless specifically included in the listing specification above or in a purchase contract. Personal property may be equipment or gear not permanently attached to the vessel including but not limited to: artwork, entertainment equipment, fishing equipment, TV receivers, recreational equipment, kayaks, tools, and personal appliances. Photos that may incidentally depict owners' personal property do not convey that such items are included in the sale of the vessel unless such items are specifically listed herein. At all times, where the particulars herein give details of a new boat and/or a new boat to be supplied/built by a builder/manufacturer, or a boat to be chartered, via our introduction, we do not guarantee or assume responsibility for the accuracy or reliability of any information offered by third-party companies in respect thereof including without limitation new boat builders/manufacturers, charter companies and/or companies/businesses which are ‘Friends of Boatshed’. We shall not be responsible for, or party to, any transactions, contracts or agreements between you and such third-party providers of products or services and it is incumbent upon you to verify such details direct with such entities and contract with them at your sole discretion and on terms that you agree.